PERMANENTLY ATTACH FLASH HIDER OR COMPENSATOR
|
|
|
|
|
SKU:
PMA-FH-COMP
PERMANENTLY ATTACH (PIN AND WELD) A FLASH SUPPRESSOR OR COMPENSATOR TO AN AR15 OR .308 AR 14.5" BARREL TO MAKE THE BARREL OVERALL LENGTH 16+".
A BLIND PIN WILL BE INSTALLED, AND WELDED (ATF APPROVED).
THE WELD WILL BE SLIGHTLY GROUND DOWN, AND TOUCH UP WILL BE APPLIED TO THE AREA.
WE REQUIRE YOU LEAVE YOUR BARREL OR UPPER WITH US FOR AT LEAST A FEW DAYS SINCE WE PERFORM THIS SERVICE DURING THE WEEKENDS.
PLEASE NOTE:
THERE COULD BE A SLIGHT DISCOLORATION OF THE FLASH SUPPRESSOR OR COMPENSATOR AT THE SPOT WELD DEPENDING ON THE TYPE OF FINISH USED ON THE FLASH SUPPRESSOR OR COMPENSATOR (ION BOND, NITRIDE, DLC) OR BY THE MATERIAL THE FLASH SUPPRESSOR IS MADE OF, EVEN AFTER BEING TOUCHED UP.
THERE WILL BE A SMALL SPOT WELD VISIBLE ON THE UNDERSIDE OF THE FLASH SUPPRESSOR OR COMPENSATOR EVEN AFTER GRINDING, AND WE WILL DO OUR BEST TO KEEP THE SPOT WELD SMALL, AND CLEAN, BUT WE DO NOT MAKE ANY GUARANTEES.
IF YOUR BARREL REQUIRES REMOVAL FROM YOUR UPPER FOR THE PUROSES OF PINNING AND WELDING A FLASH SUPPRESSOR OR COMPENSATOR TO THE BARREL, THERE WILL BE A $30.00 TEAR DOWN AND REASSEMBLY CHARGE.
IF YOU SUPPLY THE FLASH SUPPRESSOR OR COMPENSATOR, AND IT IS FOUND TO BE INSUFFICIENT IN LENGTH TO MAKE A 14.5" BARREL 16"+, THEN YOU WILL BE REQUIRED TO SUPPLY US THE CORRECT LENGTH FLASH SUPPRESSOR OR COMPENSATOR.
IF YOU SUPPLY A FLASH SUPPRESSOR OR COMPENSATOR, AND IT IS FOUND TO BE DEFECTIVE, OR WE CANNOT PROPERLY INSTALL IT TO YOUR BARREL, YOU WILL BE REQUIRED TO SUPPLY US A REPLACEMENT FLASH SUPPRESSOR OR COMPENSATOR.
RETURN SHIPPING TO THE CUSTOMER IS NOT INCLUDED IN THE COST
ADDAX TACTICAL IS NOT RESPONSIBLE IF A CUSTOMERS BREAKS THE LAW REMOVING THE PINNED AND WELDED FLASH SUPPRESSOR AND / COMPENSATOR.
|
|
|
|
|
|
|
|
|
|
